The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 30, 2012, 04:33 PM   #1
Dangerwing
Senior Member
 
Join Date: April 9, 2007
Location: South Dakota
Posts: 237
hi point 9mm carbine sling stud

Im looking for some technical advise. I recently bought a used Hi Point model 995 9mm carbine. It shoots surprisingly well and over all I'm very happy with it. There is one glitch though - the rear sling stud is mounted on the right side of the stock. This would be great if I was left handed, but I'm not. I disassembled the stock (splits in half along the length of the stock), but I can't figure out how to removed the threaded nut that is in the stock so I can move it to the other side. Is it just press fit in there? Is it removeable? Any help would be appreciated.

Thanks
__________________
Alcohol Tobacco and Firearms should be an aisle at Wal-Mart, not a government agency!

Only faithful men teach their wives to shoot.
Dangerwing is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:17 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05553 seconds with 7 queries