The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Curios and Relics

Reply
 
Thread Tools
Old July 28, 2012, 03:50 PM   #1
ks_wayward_son
Senior Member
 
Join Date: July 19, 2007
Posts: 249
Yugo M57 Recoil Spring assembly/dis

Has anyone tried to swap out the recoil spring for the M57? I know that a retaining pin has to be removed because the rod and spring is a single unit. I have read that standard TT33 springs can be used as a replacement. Reason I'm wanting to do this is because the slide doesn't lock back on the final spent casing, and when racking the slide on the first initial round, there does not seem to be enough tension to fully seat the round. I have two magazines and this situation occurs on both, not just one or the other. Thanks.
ks_wayward_son is offline  
Old July 29, 2012, 04:15 AM   #2
ronz
Senior Member
 
Join Date: January 12, 2012
Location: milwaukee wi
Posts: 220
Never done it but don’t look to be too difficult just probably going to be a pita to get it back together though
How’s the slide stop? One way to check it is to remove the slide and put in the mag and make sure the stop is being pushed up by the follower
I bought one used and didn’t notice until I got it home that the po ground down the slide stop
ronz is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:07 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05460 seconds with 9 queries