The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 20, 2012, 01:53 AM   #1
StrawDog
Senior Member
 
Join Date: June 27, 2005
Posts: 152
S&W 41 light primer strikes

Hello

I have a very high mileage S&W 41 that has grown erratic. Shoots fine for awhile then will hardly touch the rim. Local gunsmith reamed the chamber and it ran fine for about 400 rounds and then went back to erratic hits. I don't believe the ammo is an issue because I purchase bulk quantities of CCI standard velocity. I wonder if the gun may need springs etc. When light strikes happen, the slide appears fully forward. I've dry fired it and shot it a lot with very few issues for 43 years. Mostly mag problems that I can remember.

Thanks for you ideas.
StrawDog is offline  
Old July 20, 2012, 08:14 AM   #2
wyop
Senior Member
 
Join Date: July 15, 2012
Location: Wonderful, Windy Wyoming
Posts: 133
If you've dry fired it much, the firing pin might be peened or set back now. Have you taken it apart and examined the firing pin closely?
wyop is offline  
Old July 20, 2012, 10:52 AM   #3
StrawDog
Senior Member
 
Join Date: June 27, 2005
Posts: 152
Good idea. I've never disassembled the slide assembly. Any ideas where I can find disassembly instructions?
StrawDog is offline  
Old July 20, 2012, 12:28 PM   #4
Old Grump
Member in memoriam
 
Join Date: April 9, 2009
Location: Blue River Wisconsin, in
Posts: 3,144
Remove the rear sight to find the release. It's not a big deal, When you get it clean and inspect the firing pin clean the channel and spring with a good solvent and never let grease or oil get to it. If the firing pin is peened it will be obvious and easy to replace. Whenever I clean my 41 one of the last things I do is squirt carburetor cleaner into the firing pin hole and blow out with my compressor. Since 1972 I have had to strip it 3 or 4 times and replace the pin once. That was pre compressor days and when I was doing a lot of dry firing without a snap cap.
__________________
Good intentions will always be pleaded for any assumption of power. The Constitution was made to guard the people against the dangers of good intentions. There are men in all ages who mean to govern will, but they mean to govern. They promise to be good masters, but they mean to be masters.
--Daniel Webster--
Old Grump is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:29 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06536 seconds with 9 queries