The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old July 5, 2012, 08:24 AM   #26
ScottRiqui
Senior Member
 
Join Date: January 27, 2010
Location: Norfolk, VA
Posts: 2,905
What they're calling "high speed" bullets are what you see referred to in most places as "plated bullets". The paragraph you quoted equates the two terms, but not until the very end.

Generally, you use cast bullet data for plated bullets.
ScottRiqui is offline  
Old July 5, 2012, 09:24 AM   #27
Pond, James Pond
Senior Member
 
Join Date: July 12, 2011
Location: Top of the Baltic stack
Posts: 3,235
Great, thanks!!

I'll start cross referencing data., again

As it happens, some loading data that came on the back of my Lee Die Kit instructions lists 125gr, copper plated bullets in my exact weight.
RESULT!!!

Alas, not for the .44s, but at least that is one less to worry about!
__________________
You cannot wake someone who is pretending to sleep. Stop pretending. Wake up.
Freedom: Please enjoy responsibly.
Pond, James Pond is offline  
Old July 5, 2012, 07:31 PM   #28
Misssissippi Dave
Senior Member
 
Join Date: December 5, 2009
Posts: 1,407
Normally speaking you can load plated bullets the same as you would lead bullets of a similar shape. These will be using less powder then jacketed bullets. Try finding a similar shape and weight lead bullet for the .44 and use that data.
Misssissippi Dave is offline  
Old July 6, 2012, 09:42 AM   #29
CrustyFN
Senior Member
 
Join Date: June 4, 2006
Location: West Virginia
Posts: 2,258
Just an FYI for those that think you have to use lead data with plated bullets this is from Berry's. I personally have never used lead data for plated bullets.

Quote:
Plated bullets occupy a position between cast bullets and jacketed bullets. They are soft lead, but have a hard outer shell on them. When loading plated bullets we have found best results using low- to mid-range jacketed data in the load manual. You must use data for a bullet that has the same weight and profile as the one you are loading. Do not exceed mid-range loads. Do not use magnum loads.
Velocities depend on the caliber, but as a rule of thumb, we recommend you don't shoot our plated bullets over 1250 feet-per-second. Our 44's actually shoot best around 1150 fps. 45's are generally good at 850-900 fps. Our bullets are not recommended for magnum velocities over 1250fps unless the bullet description denotes a thick plated bullet with a higher listed maximum for velocity.
__________________
I don't ever remember being absent minded.
CrustyFN is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:32 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07060 seconds with 7 queries