The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old June 30, 2012, 03:07 PM   #1
jbondor
Junior Member
 
Join Date: October 18, 2006
Posts: 11
Rem. Model 550-1 .22 autoloader

I have the above rifle. It has a screw in plug at the rear of the action. The threads on the inside of the action have been slightly crossthreaded so the plug won't go in. The threads measure 20mm X 1.25 I am told. No one locally has that size tap that I've been able to locate and a special order costs around $135. Any suggestions on how to clean the inside threads without buying a special tap. Thanks.
jbondor is offline  
Old June 30, 2012, 04:24 PM   #2
Fleet
Senior Member
 
Join Date: December 1, 2011
Posts: 108
The threads in this action aren't metric. I had this problem come in earlier this year. I believe I used a 1/4-20 tap (the receiver is threaded 20 threads per inch) to act as a thread comb. It takes a while, and a bit of effort, but you can clean it up that way. Just put the tap in the receiver, and start scraping back and forth around the inside of the action. It'll smooth out.
Fleet is offline  
Old June 30, 2012, 06:17 PM   #3
jbondor
Junior Member
 
Join Date: October 18, 2006
Posts: 11
Thank you. I'll give it a try. I greatly appreciate the rapid reply and the tip.
jbondor is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:53 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06676 seconds with 9 queries