The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old June 24, 2012, 10:49 AM   #1
Alan Duke
Senior Member
 
Join Date: September 1, 2009
Location: Tomball,TX
Posts: 111
Mossberg 935

Any one know where I can find a firing pin,return spring tube and plunger,and retaining link for the gas system? I've tried Numrick and a few other sites with no luck.

The gun fires once with a full tube and then will not fire. It loads the second round, but will not fire.

Thanks in advance................ Alan
Alan Duke is offline  
Old June 24, 2012, 11:40 AM   #2
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,416
Have you tried Mossberg's customer service? Typically, when a gun is still in production, like a 935, the maker will supply parts. After a gun is discontinued, some makers will sell off their parts inventory to the likes of Numrich.
zippy13 is offline  
Old June 24, 2012, 12:34 PM   #3
Orphanedcowboy
Senior Member
 
Join Date: April 16, 2009
Location: Fort Worth, Texas
Posts: 193
Sounds like there is more going on than just replacing parts will fix. Have you thoroughly stripped the gun and cleaned it, including removing the shell stop? If not start there, trash behind the shell stop on a 930/935 will cause feed and fire issues.
__________________
NRA Life Member
Orphanedcowboy is offline  
Old June 25, 2012, 11:16 PM   #4
Alan Duke
Senior Member
 
Join Date: September 1, 2009
Location: Tomball,TX
Posts: 111
Thanks .....OC/zippy.............We tore it all the way down and removed all the "grease" the prior owner used on it. ( I won't get started on that ). It was then lightly oiled and test fired again with the same issues. I don't know enough to diagnose the problem beyond that.
Alan Duke is offline  
Old June 27, 2012, 07:27 PM   #5
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
Have you determined that after the second round is chambered the bolt is all the way into battery? If you push the bolt handle forward does it then go into battery?

Last edited by TheKlawMan; June 27, 2012 at 07:40 PM.
TheKlawMan is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:06 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07018 seconds with 9 queries