The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old June 19, 2012, 11:19 AM   #1
Doug Bowser
Senior Member
 
Join Date: May 6, 2005
Posts: 161
Trouble with C&B Dragoon

I have a Replica Arms 2nd Model Dragoon by Uberti. It functions well until the trigger is pulled. Then the cylinder lock jumps out of the cylinder lock notches and the cylinder turns slighly before the hammer hits the ege of the notch cut out for the nipples. I bought a new cylinder stop and it does not fit. Should I check how much the bolt stop sticks above the frame? I have replaced a broken sear spring and I have the bolt stop part of the spring exerting a lot of pressure on the bolt stop. What would be my next step? Can I safely grind off the top of the bolt stop leg and allow the bolt stop to rise higher out of the frame?

Doug
Doug Bowser is offline  
Old June 19, 2012, 08:41 PM   #2
swopjan
Senior Member
 
Join Date: August 12, 2011
Posts: 156
you might have better luck in the black powder section. lots of tinkering goes on over there, somebody may have had your same problem.
swopjan is offline  
Old June 19, 2012, 08:48 PM   #3
Aguila Blanca
Senior Member
 
Join Date: September 25, 2008
Location: CONUS
Posts: 6,693
VTI Replica Gun Parts in Connecticut is some sort of official Uberti off-shoot. They have a gunsmith in NY state (they are near the CT/NY state line) who does repairs. I'd suggest contacting VTI.
Aguila Blanca is offline  
Old June 19, 2012, 09:14 PM   #4
Bear River
Member
 
Join Date: May 20, 2010
Location: The Cowboy State
Posts: 45
Uberti has a good repair service. Just call them they issue a work order number etc. The last Dragoon I sent in was turned around in 8 days.
Bear River is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:16 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06266 seconds with 9 queries