The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old June 10, 2012, 06:59 PM   #1
keysort
Junior Member
 
Join Date: June 10, 2012
Posts: 4
Winchester 1897 Action Issues

Junior Member

Join Date: June 10, 2012
Posts: 1

Winchester 1897 Dilemma
Hello, everyone!
I bought a ratted out Winchester 1897 to make into a trench gun repro. I'm pleased with the outcome of my project, but I'm having an issue with the gun.

When I try to cycle the action, the carrier seems to hang up on the face of the shell in the mag tube. If I press the round forward slightly in the tube, the gun cycles fine. Have any of you seen this issue? I can't decide if the mag tube is sitting out of position, or if the carrier is slightly too long to accommodate the shells...any suggestions?

Here's a photo for your viewing pleasure! (I now have the stop screw that is not present in the photos)



keysort is offline  
Old June 11, 2012, 08:52 AM   #2
g.willikers
Senior Member
 
Join Date: September 28, 2008
Posts: 5,325
Generally, when a round from the mag sneaks out to cause a jam, the cause is the part that's supposed to prevent that.
It's called the cartridge stop; there's actually two, right and left.
It's the long skinny part that runs along the side of the receiver with a curved end that controls the rounds in the mag.
It should be easy to see from the bottom.
It might be just dirty and sticking to the receiver or it could be bent, or possibly old enough to have lost its springiness.
__________________
Lock the doors, they're coming in the windows.
g.willikers is online now  
Old June 11, 2012, 09:35 PM   #3
keysort
Junior Member
 
Join Date: June 10, 2012
Posts: 4
The problem wasn't the cartridge guide. The mainspring wasn't installed correctly. It hung over the edge of the carrier by a fraction of an inch. Now that it's in place, the gun functions flawlessly!
keysort is offline  
Old June 11, 2012, 11:39 PM   #4
sltm1
Senior Member
 
Join Date: February 25, 2009
Location: Idaho
Posts: 306
I have one myself and after a few replacement partd (using old mfgr'd stuff), it works new. Glad you worked out the problem, mine had stripped threads on the magazine an was a bear to figure out.
sltm1 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06446 seconds with 9 queries