The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old June 21, 2012, 11:06 AM   #26
brickeyee
Senior Member
 
Join Date: December 29, 2004
Posts: 3,342
Quote:
The torque stretches the screw and put proper tension on the head to keap it from slipping and thus loosening.
And there are probably far more applications that cannot tolerate locking torque than ones that can.

There are also applications that using locking torque is simply inadequate for the environment.
brickeyee is offline  
Old June 21, 2012, 12:21 PM   #27
pgdion
Senior Member
 
Join Date: April 22, 2010
Location: MPLS, MN
Posts: 1,109
Quote:
The only place I use Loctite (blue) on weapons are scope mounts, scope rings, and action screws torqued to the proper values.
And the rear sight elevation screw of the Beretta NEOS.
__________________
597 VTR, because there's so many cans and so little time!
pgdion is offline  
Old July 26, 2012, 02:41 PM   #28
scout338
Junior Member
 
Join Date: January 10, 2011
Posts: 2
For scope base screws I lubricate, torque to spec, loosen, torque to spec again, remove screws, degrease, blue Loctite and finally torque to spec. Best of both worlds.
scout338 is offline  
Old July 26, 2012, 04:14 PM   #29
a7mmnut
Junior member
 
Join Date: February 27, 2009
Location: NC Foothills
Posts: 1,150
Threads don't lock that way, anyhow. There are many clearance variations between the male and female minor/major diameters of the fastener and the threaded hole. The thin leading taper edge of the male thread contacts only a portion of the insert thread wall. That leaves the head of the fastener and the spacer or cap washer holding most of the torque anyway. Then, here comes your Loctite...



-7-
a7mmnut is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:50 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07088 seconds with 8 queries