The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Competition Shooting

Reply
 
Thread Tools
Old July 8, 2012, 03:24 AM   #1
Ervin
Junior member
 
Join Date: October 9, 2009
Posts: 125
Using a two stage pistol in the rapid

With gas rifles I usually hold the trigger back after the round goes down range and I release a bit slack on that trigger till I hear the 1st stage reset.
From there I only have to pull 1st stage to get the 2nd shot off.

My question are....does this also apply to pistols with 2 stage triggers?
2. are most 1911s equipped with the 2 stage?
3. What actually resets inside when you let go of the trigger level a little?
Ervin is offline  
Old July 8, 2012, 07:25 AM   #2
g.willikers
Senior Member
 
Join Date: September 28, 2008
Posts: 5,062
There's really no set answer to your question.
Pistols and revolvers are available in many designs, and they can be quite different.
There's striker fired ones, that usually have a distinct takeup and reset.
There's double/single actions as well as double action only.
There's single action only, like 1911s, Browning High Powers and others.
All with hammers and firing pins instead of strikers.
They can have the long takeup and short reset positions of the trigger - or not.
It varies from design to design as well as between individual guns.
As for 1911s, I've run across them with absolutely no takeup.
And others that have a lot of takeup and a short reset, as compared to the total trigger travel, almost like a striker design.
No telling without trying them, sometimes.
Did this answer help or add to the confusion?
__________________
Lock the doors, they're coming in the windows.
g.willikers is offline  
Old July 9, 2012, 10:36 AM   #3
Nanuk
Senior Member
 
Join Date: January 2, 2005
Location: Where the deer and the antelope roam.
Posts: 1,690
With revolvers you have to allow the trigger to go fully forward before you can fire again, as with some DOA pistols. Glocks and 1911's generally have a short trigger travel and a short reset. With a pistol, there is no way you can reset the trigger between firing the gun and the slide operating, my experience is the same with rifles. What you can do is "miss" the reset by not allowing the trigger to go far enough forward. That being said, every successive shot, the trigger must reset before you can fire another round. On my Glocks especially, I can feel the reset "click" if I try to, I have shot it enough its pretty automatic.

I personally do not care for 2 stage triggers on AR's either, I grew up shooting plain old rifles with single stage triggers, why change now?
__________________
My rifle and pistol are tools, I am the weapon.
Nanuk is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:35 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06913 seconds with 9 queries