The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old May 24, 2012, 11:10 AM   #26
Axelwik
Senior Member
 
Join Date: March 12, 2012
Location: Land of Enchantment
Posts: 353
Quote:
No. If the case would even enter the die, you would just be taking out the flare that you just put on.

I have never seen a die set with the decap rod in the flare die.

You sure about that one?

Sent from MIUI using Tapatalk 2.
I have an old RCBS pistol die set (.38/.357) with the decapper in the flaring die.
Axelwik is online now  
Old May 24, 2012, 01:48 PM   #27
eldorendo
Senior Member
 
Join Date: May 8, 2012
Posts: 224
Fortunately, I guess I'm just not "most folks!" I use primarily Lee dies with my Dillon 650 press. I don't own any Dillon dies. I do have some Redding dies in .40 Super, but don't load .40 Super anymore.

I doubt that "most folks" use the same brand dies as presses.
eldorendo is offline  
Old May 24, 2012, 09:48 PM   #28
dacaur
Senior Member
 
Join Date: March 16, 2010
Posts: 733
I use lee dies with my lee press only becuase they are the best value. If another brand of dies offerd better value, I would use that.
dacaur is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:36 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06003 seconds with 7 queries