The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old May 21, 2012, 01:33 PM   #1
kenham
Junior Member
 
Join Date: March 23, 2012
Posts: 12
Remington 740 recoil pad?

I have my recently acquired 740 whose recoil pad is hard as a rock. I would like to put a Pachmayer recoil pad on but can't determine the correct part. I phoned Pachmayer but the lady was not able to help. I have a Brownell catalog but still can't find the right part number. The stock is wood, the butt not curved. Is there a made to fit pad or is this something that needs to be done by a gunsmith? Thanks in advance.
kenham is offline  
Old May 21, 2012, 02:56 PM   #2
Doyle
Senior Member
 
Join Date: June 20, 2007
Location: Starkville, MS (new to MS)
Posts: 4,855
Simple - get a grind-to-fit. There is a good Larry Potterfield video on Youtube showing how to grind one. Of course, he uses a fancy jig to hold it while he grinds on a circular sander but you can do the same thing with a scrap piece of wood and a regular belt sander. I've done two now that came out perfect and I just ordered two more to do.
Doyle is offline  
Old May 22, 2012, 10:36 AM   #3
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
There are NO "drop-on" pads to fit your rifle AFAIK - every pad will need to be individually fitted.

Just be sure to buy one a bit larger than the bare end of the buttstock.

The best way would be to remove the old pad via unscrewing it's two screws (hidden - look for 2 slits in the rubber) and compare it the pads F/S at local gunshops.

If the new pad's screws don't align with the old holes, fill the holes with carved wood dowels & drill one or two new holes in the proper location.

If you grind down the oversize/new pad, be sure to follow/extent the existing stock bottom, top, & side lines straight to the rear end of the new pad - or the result will appear clumsy at best.

You should wrap the end of the stock sides, etc, with masking tape before fitting, to protect the existing stock finish.
If it's done carefully, a professional-looking job can result.

.
PetahW is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:16 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05677 seconds with 7 queries