The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Hunt

Reply
 
Thread Tools
Old April 30, 2012, 12:41 PM   #1
Southern Shooter
Senior Member
 
Join Date: May 4, 2005
Location: central Louisiana
Posts: 446
Lee TL430-240 SWC Effectiveness

It is clear that the meplat of the Lee TL430-240 SWC is not flat with sharp edges or very large. I am just wondering if that bullet, pushed to 1,150-1,200 FPS and using wheel-weights for material, would be effective defensively on things like hogs, black bear, moose, etc.

Or, would the meplat really make that big of a deal??

Thanks
TL430-240 SWC.jpg
__________________
"My plea is that we stop seeking out the storm and enjoy more fully sunlight. I am suggesting that as we go through life we accentuate the positive. I am asking that we look a little deeper for the good, that we still our voices of insult and sarcasm, that we more generously compliment and endorse virtue and effort." Gordon B. Hinckley

Last edited by Southern Shooter; April 30, 2012 at 12:51 PM.
Southern Shooter is offline  
Old May 26, 2012, 06:10 AM   #2
Mike / Tx
Senior Member
 
Join Date: April 8, 2000
Posts: 1,317
The Lee will throw some good bullets and with WW alloy will effectively do the job on a hog or deer. Sweetened it up a bit with some pure lead it will probably give you some better expansion as well. Either way, your still going to be putting a nearly half inch hole in, and in most cases, through the intended target, so shot placement will be about your biggest concern.

That said, if you haven't purchased the Lee mold already you might look up MP Molds and shoot him a note on the availability of one of his Mp 423-256 molds. It will cost a tad more, but if he has one get it. In the long run you will have one mold which will serve just about any purpose you will ever need with your 44.

I have one myself and it throws wonderful bullets in both FN and HP's. You will need to soften up the straight WW alloy in order to get the proper expansion with the HP's, but it is very easily done with some range lead or pure lead. The money will be well spent on it, and you will not be disappointed in the craftsmanship or the end product. If you get one, use a thermometer in your pot and bring the alloy up to about 720 - 730 degrees, and preheat the mold on a small hot plate while your alloy heats up. Once everything is up to temp you will not want to stop pouring them.

Check out the articles presented here,
Glen E. Fryxell, Cast bullets and firearm information and history

Download his free book " From Ingot to Target" while your there, and be sure to also check out the link in the top right corner, " Cast Bullet Notes".

Hope this helps.
__________________
LAter,
Mike / TX
Mike / Tx is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:37 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06785 seconds with 8 queries