The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools
Old April 29, 2012, 11:18 AM   #1
Senior Member
Join Date: February 12, 2008
Location: NC
Posts: 316
Stuck magazine tube!

Picked up a Winchester 250 lever action 22 rifle recently as a project. The innet magazine tube seems to be stuck and no matter what I do I can't get the thing out. From the damage on the end of it, it looks like they tried pulling it out with some kind of pliers.

So what do you guys/girls suggest? I'm thinking of soaking it in penetrating oil for a few days and see if that helps. Have not had but a minute to mess with it but I need to strip the receiver down amd see if somethings jammed up in there which is causing the binding/jam.

Sent from my PC36100 using Tapatalk 2
fortkevin2 is offline  
Old April 29, 2012, 07:57 PM   #2
Senior Member
Join Date: September 19, 2008
Posts: 4,679
I would remove the forend wood & apply mild heat to the outer mag tug at the same time the inner tube is being pulled out from it.

If the inner tube isn't gunked up, a shot of sanding with fine emory paper should slick up the brass.

Don't forget, as many do, to also clean/scrub the inside of the outer tube.

PetahW is offline  
Old April 29, 2012, 09:44 PM   #3
Senior Member
Join Date: September 13, 2005
Posts: 3,302
I would try penetrating oil, if say a live round was jammed in there I would not want to apply heat.
SIGSHR is offline  

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:40 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05794 seconds with 7 queries