|February 26, 2012, 05:15 PM||#1|
Join Date: January 21, 2012
Powder check die on a Lee Loadmaster
Hello again, folks.
I come with yet another question, as I'm exploring a few possibilities of my current setup. I'm really liking the idea of having a powder check die on my press as of recent for ease of use and mind. But the questions is; Where do I put the dang thing. Any suggestions? My setup is very standard and is shown below:
Loading .357 magnum, .38 special, and .40sw.
1-Decap and resize
3-Bell case and powder charge
How would I fit a powder check die here without going back to crimping and seating at the same time (not as consistent as I like it to be)?
I was thinking of adding a step into station two, but common sense and self preservation tell me that charging whilst priming is a no-no.
Any help is always much appreciated.
”An unarmed man can only flee from evil, and evil is not overcome by fleeing from it.”
~Col. Jeff Cooper
|February 27, 2012, 02:38 PM||#2|
Join Date: January 5, 2009
Location: Just off Route 66
Since 38 spl and 357 Mag uses a roll crimp, you should be using your seating die for this and not the FCD, and since 40 S&W does not use a crimp, you should have an extra slot open if using the 4 hole Lee Classic Turret press that you can use for your powder check die.
For rifle I do all case prep and priming before using the press and this is what it looks like.
Si vis pacem, para bellum
|Thread Tools||Search this Thread|