The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old February 8, 2012, 03:02 PM   #1
SRE
Member
 
Join Date: May 15, 2011
Location: Southern York County, PA
Posts: 91
.22 Hornet Reloading question...

Ok so I just started reloading the .22 Hornet after I stumbled across a Ruger 77/22 chambered in 22. Hornet and COMPLETELY fell in love with this thing. (Why I love it is a whole other post in itself)

Ok so my reloading question is: When I full length size/ neck size, the decapper rod pushes through the flash hole essentially making it bigger causing me to obviously have to deburr for proper seating of the primer. Is this normal? Happens both with my Lee Dies and RCBS Dies. Only have reloaded Hornady Brass. Maybe the flash holes on standard Hornady Factory brass for the Hornet is smaller? Anyone else have flash hole issues with reloading the .22 Hornet?

Also... what's your opinion on Barnes Varmint Grenade bullets? They as accurate as Barnes describes?

Thanks in advance!
__________________
Combat Commander
SRE is offline  
Old February 8, 2012, 05:12 PM   #2
dahermit
Senior Member
 
Join Date: October 28, 2006
Location: South Central Michigan...near Ohio, Indiana.
Posts: 3,505
I have not encountered the problem you describe with either Remington or Winchester .22 Hornet brass using a Lee Collet neck die to size, decap.

My load of choice is: Rem small rifle primer, Reminton brass, Calhoon 45 grain double hollow point bullet over 10.5 of Lil'Gun powder.
__________________
Sometimes you get what you pay for, sometimes you only pay more for what you get.
Three shots are not a "group"...they are a "few".

If the Bible is the literal, infallible, unerring word of God...where are all those witches I am supposed to kill?
dahermit is offline  
Old February 8, 2012, 05:32 PM   #3
Ideal Tool
Junior member
 
Join Date: October 6, 2010
Location: Michigan
Posts: 1,080
Hello, SRE. I too handload for this wonderful little ctg. Yes, I have been using the excellent RWS brass..sadly no longer being imported, this has quite small flashholes.
I have gotten in the habbit of de-priming with a seperate base & punch & light plastic mallet for all of my loading..keeps the primer grit out of press & dies. I have made up smaller dia. de-prime punches from #drill shanks.
You might want to chuck up those pins in drill press, or handrill & reduce dia. probably too hard for files, but a coarse hone with oil should do it.
Good luck & have fun with your Hornet!
Ideal Tool is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:06 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05799 seconds with 7 queries