The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 24, 2012, 10:24 AM   #1
nazier
Junior Member
 
Join Date: January 9, 2012
Location: cape town south africa
Posts: 5
O A Length

Hi.
Bi how much can i trim my rifle casses below the maximum O A Lenth
nazier is offline  
Old January 24, 2012, 10:32 AM   #2
AllenJ
Senior Member
 
Join Date: December 11, 2009
Location: Northern California
Posts: 1,383
All the reloading manuals I have used give this information and it's always been trim .010" from the max for the cartridges I've loaded for. I would suggest checking your manual though for your specific cartridge.
AllenJ is offline  
Old January 24, 2012, 12:14 PM   #3
Unclenick
Staff
 
Join Date: March 4, 2005
Location: Ohio
Posts: 10,485
Nazier,

The way SAAMI specs on cases work is they specify a maximum with a minus tolerance. The tolerance is different for different cases, but for most rifle cases it is -0.020". The trim-to number you see in some manuals is simply in the middle of that tolerance to give you the most room for error either side of it.

SAAMI allows free access to their specs published in 1992. A number of cartridges have been added since then, but the common standard rounds are in the old information. You find your cartridge in the lists in the first half of the document and those drawing have the cartridge on top and the chamber below. The second half of the document includes pressure and velocity test barrel information.

All that said, for some cartridges you can trim below SAAMI spec. A lot of service rifle match shooters used to trim to -.035 to -.040 below SAAMI maximum when a case was new just so they could trim once and never trim again before they wore them cases out, which happens faster in a semi-auto gas gun than in a bolt gun. That practice is not best for consistent neck tension and is not useful in cases that will be crimped, but for non-crimped match loads for offhand and the sitting and prone rapid phases, the accuracy is fine.
__________________
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member
Unclenick is offline  
Old January 25, 2012, 02:53 PM   #4
nazier
Junior Member
 
Join Date: January 9, 2012
Location: cape town south africa
Posts: 5
Trim lenth

Thanks for the info.. i seem to have lost my hornady manual while moving house and cant find one in my side of the world
nazier is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:04 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06644 seconds with 7 queries