The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old December 4, 2011, 11:06 AM   #26
Senior Member
Join Date: May 3, 2009
Location: Central Texas
Posts: 3,380
I can say this is how I would handle it.

Order a Lee Collet Neck Sizing Die

Load said short brass and shoot it. (While waiting on collet die to arrive.) After shooting measure it. If still under the trim to length then when the collet die arrives load, and shoot brass till it either splits at the case mouth, or needs to be trimmed. Paper clip test each case for any signs of head seperation.

I do not care about length for rounds in my bolt gun as long as they are not at too long. I do not crimp so I am not real worried. My accuracy with my rifle is under three quarters MOA on an awful day. Usualy more like quarter to half MOA if I am doing my part correctly.
No matter how many times you do it and nothing happens it only takes something going wrong one time to kill you.
m&p45acp10+1 is online now  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:19 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.12567 seconds with 7 queries