The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 24, 2011, 09:51 PM   #1
fasttwitch
Junior Member
 
Join Date: September 24, 2011
Posts: 1
Winchester model 70 help

I just aquired a model 70 300 h&h. I have never had a model 70 before. It was in need of some good cleaning. My question is about the bolt, I found on the internet to remove the bolt, unscrew it from the sleeve and clean it. I did that and reinstalled it. What i found when i reinstalled it, is that after it is in cocked and ready to fire if i dry fire it the bolt rotates slightly counterclockwise. I never paid attention to it enough before to see if thats what they do. It doesnt rotate much at all but it does i can watch the bolt checkering and see it. I never owned a winchester and wanted to know if this is what they do? thanks.
fasttwitch is offline  
Old September 24, 2011, 10:24 PM   #2
modgodcom
Junior Member
 
Join Date: September 24, 2011
Posts: 5
Its a safety feature

On practically all bolt action rifles after the cock on open revolution (Mauser 98), a safety has been inherent to the camming action on the bolts. Basically, the cocking piece must clear the camming surface on the bolt body before the firing pin will contact the primer. What this means is that if the bolt handle isnt all the way down (meaning the rifle is out of battery), the cocking piece will move the bolt into full battery to prevent a Sudden Chambered Load Induced Disassembly (SCLID). I believe on the model 70 this is actually normal on dry fire, just check to make sure your safety lug doesnt have any contact marks and take it to a gunsmith for a headspace check.

Last edited by modgodcom; September 24, 2011 at 10:31 PM. Reason: Poor nomenclature
modgodcom is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:48 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05019 seconds with 7 queries