|
September 14, 2011, 10:32 PM
|
#1 |
|
Senior Member
Join Date: July 24, 2011
Location: Texas
Posts: 529
|
9mm slug
would it be abnormal for the grooves in a 9mm pistol bore to mic at .356 or .357?
|
|
|
September 14, 2011, 11:52 PM
|
#2 |
|
Senior Member
Join Date: January 25, 2005
Location: Mississippi/Texas
Posts: 2,348
|
Typically .356, but .357 wouldn't be especially strange.
__________________
"Suppose you were an idiot, and suppose you were a member of Congress, but I repeat myself." Mark Twain |
|
|
|
September 16, 2011, 10:39 PM
|
#3 |
|
Senior Member
Join Date: March 5, 2009
Location: Varying between 1 and 3 hours from Chicago
Posts: 151
|
I just slugged the barrel on my 92fs and it was rolling them out at .358.
__________________
Rev 5:13 "To him who sits on the throne and the Lamb be praise honor and glory and power, for ever and ever" |
|
|
|
September 16, 2011, 10:53 PM
|
#4 |
|
Senior Member
Join Date: July 24, 2011
Location: Texas
Posts: 529
|
my gun is also a beretta but a px4. i think it is a very good gun overall, but with your input and the guns being the same brand i wouldnt be surprised to see .357 or so. ill slug the barrels tomorrow to know for sure
|
|
|
|
September 16, 2011, 11:23 PM
|
#5 |
|
Senior Member
Join Date: December 2, 2007
Location: South TX
Posts: 264
|
Earlier this year I had a squib go to near the end of a CZ 4.72" bbl (long story).
It was jacketed, but I measured it anyway. It measured .356/.357 |
|
|
 |
| Thread Tools | |
|
|
