The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old August 23, 2011, 04:09 PM   #1
countryboyejb
Junior Member
 
Join Date: February 27, 2011
Location: Bucyrus, Ohio
Posts: 9
Variance in weight and length

What is an acceptable variance in bullet weight and lenght. I have about 200 Reming PSP W/C that vary .02 in length and .8 grains in weight. Also is the lenght difference enough to change pressures due to differences in case capacity because of seating depth changing the amount of open space in loaded cartridge?? Does this make sense???
countryboyejb is offline  
Old August 23, 2011, 05:25 PM   #2
PA-Joe
Senior Member
 
Join Date: June 9, 2010
Location: NEPA
Posts: 729
This is normal. If you look at the lead tips you will find many are deformed. That is why we measure the ogive instead of the tip. Some reloaders will sort their brass and bullets by weight. The slight change in lenght will not have an effect on pressure providing you are not loading hot.
PA-Joe is offline  
Old August 23, 2011, 06:18 PM   #3
Doyle
Senior Member
 
Join Date: June 20, 2007
Location: Starkville, MS (new to MS)
Posts: 4,767
More normal in some bullets than in others. My reloading buddy tried Berger VLD's in .264. Their weights were extremely consistent but their lengths were so bad that you could stack them side-by-side and see the differences. He now uses his remaining supply only to fireform brass to AI.
Doyle is offline  
Old August 23, 2011, 06:39 PM   #4
Ideal Tool
Junior member
 
Join Date: October 6, 2010
Location: Michigan
Posts: 1,080
Hello, I am a cast-bullet fanatic. I had worked up an accurate load in my Hornet & .222 Rem. that equaled the best match-bullet accuracy. Now I weigh each of those little pills in order to acomplish that. I had bought some Berger match bullets for load development in a .219 Wasp. On a whim, I decided to weigh them..I was shocked to see such a weight span..I usually hold my cast .22's to + or - .1 gr. these were all over the shop!
Ideal Tool is offline  
Old August 23, 2011, 06:55 PM   #5
countryboyejb
Junior Member
 
Join Date: February 27, 2011
Location: Bucyrus, Ohio
Posts: 9
Thanks, just curious if that could cause flyers. Thanks again
countryboyejb is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:06 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06478 seconds with 7 queries