The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > NFA Guns and Gear

Reply
 
Thread Tools
Old May 2, 2011, 11:45 AM   #1
TheRookie6
Junior Member
 
Join Date: May 2, 2011
Posts: 5
H&R Pardner question

I just picked up a my first shotgun from my local gun shop. Its a single action H&R pardner 12ga. It says on the barrel that it shoots 3" shells. My question is, can I shoot 3" AND 2 3/4" inch shells? any help would be appreciated. I'm new to this forum and new to shotguns. Thanks!
TheRookie6 is offline  
Old May 2, 2011, 01:56 PM   #2
PawPaw
Senior Member
 
Join Date: December 24, 2010
Location: Central Louisiana
Posts: 3,115
This isn't an NFA question, but I'm sure the mods will be along shortly to move this thread to the shotgun forum.

While we're here though, we may as well address it. The H&R Pardner shotgun is a single shot break-action shotgun. If your example says that it's chambered for 3" shells, it's perfectly safe to shoot 2 3/4 shells in it. Shooting a 3.5 inch shell would cause an increase in pressures that wouldn't be good for the gun, nor for your shoulder.

I've fired 3.5 inch 10 gauge shells from a properly chambered H&R shotgun and the recoil was memorable.

Short answer: Yes, you can shoot either 2 3/4 or 3" shells from that shotgun.
__________________
Dennis Dezendorf

http://pawpawshouse.blogspot.com
PawPaw is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:35 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06403 seconds with 9 queries