The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 30, 2011, 12:24 PM   #1
savage1r
Senior Member
 
Join Date: March 17, 2009
Posts: 313
30.06 dies to reload .308?

I've seen a few threads of people asking if their .308 dies can reload 30.06 and the main problem with that being the dies for the .308 are too short and the angle of the shoulder differs. I inherited a set of 30.06 dies and was wondering if the reverse was possible. You can always tighten a larger set of dies smaller, but you can't always do the reverse. I know the shoulder may still be an issue, but otherwise most other attributes should be fairly similar. Anyways, let me know what you think.
savage1r is offline  
Old March 30, 2011, 12:44 PM   #2
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 2,585
I use a seater die from RCBS to seat bullets for the 30/06 and the 308 and with a little effort others. the same die is used to seat bullets for the 30/06 and 308 with the addition of an extended shell holder.

Sizing with the same die does not work, the case body at the shoulder case body juncture is .011 thousands larger in diameter on the 308 than it is on the 30/06 when measured from the head of the case head to the same point on the case, again, sometimes overlooked when research is skipped or omitted as when some with a reamer and no investigative skill, they ream a 308 W. chamber to 30/06 to determine if the 30/06 reamer will remove all of the 308 chamber, or they ream the 308 chamber to 30/06, chamber a round and fire then discover a ring around the case indicating part of the chamber still exist and was not removed, I have suggested the 308 chamber to be reamed to 30/06 Ackley Improved or a 30 Gibbs.

F. Guffey
F. Guffey is offline  
Old March 31, 2011, 10:38 AM   #3
wncchester
Senior Member
 
Join Date: December 1, 2002
Posts: 2,832
"You can always tighten a larger set of dies smaller,"

Not really. A set of .30-06 dies cannot be used to load .308.
wncchester is offline  
Old March 31, 2011, 10:41 AM   #4
Saltydog235
Senior Member
 
Join Date: October 20, 2010
Location: Pawleys Island
Posts: 1,113
A set of RCBS dies is about $30.00, is it that much of a savings to skrimp on a detail that small?
Saltydog235 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:17 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06248 seconds with 9 queries