The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old March 22, 2011, 09:43 AM   #1
Join Date: March 21, 2010
Posts: 46
Reassembly Winchester Model 1400 Mk II

I bought a Winchester Model 1400 Mk II at an auction. Before firing it, I started to take down the gun, starting at the trigger group. It was grody and I decided to take it down completely and it's clean.

I can not find a detailed reference to help me with the safety buttom and the sear assy. The hammer spring is in the slot but the safety may/may not operate. I'm tired of removing/installing the pin through the hammer spring support.

The sear assy took flight while removing the disconnector and I just need to know where the loop at the end of sear spring goes and the orientation of the spring behind the disconnector.

Any help will be appreciated.
jells is offline  
Old November 28, 2011, 05:51 PM   #2
Junior Member
Join Date: November 28, 2011
Posts: 4
Winchester model 1400

Did you ever get your answer? I am having the same problem although I believe I fixed it but wanted to make sure. Also any issue with the bolt not sliding back after you put the trigger group back in?
setfreejoe is offline  
Old December 5, 2011, 10:25 PM   #3
Senior Member
Join Date: April 14, 2009
Location: Mobile, AL
Posts: 389
You might try this:
NRA Life Member
Certified in laziness
Certified in watching TV
Certified in BBQ on the Green Egg
trex1310 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:23 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05614 seconds with 7 queries