The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > NFA Guns and Gear

Reply
 
Thread Tools
Old February 1, 2011, 09:40 AM   #1
mooman
Member
 
Join Date: February 8, 2007
Location: Republic of Texas
Posts: 16
M16 buffers

Dose anyone have any experience with M16 rate reducing buffers?
mooman is offline  
Old February 1, 2011, 11:50 AM   #2
David Hineline
Senior Member
 
Join Date: December 23, 1999
Location: South Sioux City, Nebraska
Posts: 704
I am using the MGI buffer on my .223 and 9mm shorty.

I have used the AAC but could never get the reduced power spring to chamber a round properly.
David Hineline is offline  
Old February 20, 2011, 09:58 PM   #3
GarrettJ
Junior Member
 
Join Date: April 13, 2008
Posts: 12
Not in an M16, but I've had positive experiences with the AAC buffer. I use it in my TASK-style slow-fire M11/9.

I also had problems in an AR15/9mm when using a suppressor and a 16" barrel. I was getting a lot of bolt-over malfunctions. Apparently the back pressure from the long barrel and the can were cycling the bolt too fast, even with a heavy 9mm buffer. I pulled the AAC buffer out of the M11 and the AR ran fine after that. Now I have one for each of them.
GarrettJ is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06097 seconds with 9 queries