The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 28, 2010, 04:50 PM   #1
boatmonkey82
Junior member
 
Join Date: December 31, 2008
Location: youngsville nc
Posts: 195
Iver johnson restoration , need some opinions

Ok I have gotten another .38 iver johnson hammerless top break pistol . And of course it looks like a archaeological find . All of the original nickel is gone but not really pitted too bad , I tore it down 100% and shoved it into the blast cabinet which has 80 grit :barf: i know i know . This is not my first refinish but Im looking for a way to polish it out better other than spending the next week of my life with wet1k grit paper. would a tumbler work ? if so would it wear out the the important parts more so than they are now? I just finished a 357 ruger security six and 32-20 spanish revolver and both turned out very nice . Another issue is around the firing pin is pitted very bad and the lock up dimple is worn , could i not weld in the pits and the worn dimpel a bit then finish it down again ? Sounds like a lot of work for a 100.00 gun BUT it was my great grandmothers and i want it almost functional if not fully . I dont like wall hangers and a empty or broken gun is of no use to me . sorry the pic is a bit fuzzy
boatmonkey82 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:41 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05879 seconds with 9 queries