The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Reply
 
Thread Tools
Old December 3, 2010, 08:32 PM   #1
rog d
Junior Member
 
Join Date: October 28, 2010
Posts: 5
Ruger rotary magazines

A long time back, I posted concerning servicing Ruger magazines for my 77-22. I received much help, but didn't print it out. Now I am unable to retrieve the info. Can anybody help?
Rog D
rog d is offline  
Old December 4, 2010, 02:06 PM   #2
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 11,407
Use an Allen wrench to loosen the screw through the magazine body. Tap the magazine body to loosen the rear plate. You will usually hear the spring unwind as the rear plate comes loose. Disassemble and clean the magazine. Lube with spray dry lube (I like PTFE lubes, but there are others). When reassembling, preload the magazine spring by about 1 turn. Tighten the screw but there is no need to crank on it.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
Old December 4, 2010, 02:22 PM   #3
Pahoo
Senior Member
 
Join Date: February 16, 2006
Location: IOWA
Posts: 5,472
I routinely clean mine and others but not until I start to see a lot dirt, in the rotor. Some bulk ammo is very dirty. .....

Now, if you tighten the spring too tight, you could break it. Sound strange to me but have heard of folks that have broken their springs. If you get it too loose, you will have feeding problems. On disassembly, I have tried to count the number of turns provided by the factory and they wind them tight. Lately, I mostly go by feel and see what kind of pressure a fully loaded magazine gives me. I normally do not use any lube.


Be Safe !!!
Pahoo is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:29 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06205 seconds with 7 queries