The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 21, 2010, 03:54 PM   #1
mrdux
Member
 
Join Date: July 9, 2009
Location: Texas
Posts: 15
trouble with TC

I am not quite sure what is the problem with my TC encore. I think there is a problem with the extractor. Yesterday after I shot it, I had just a small bit of trouble feeding a new shell in. When I tried to open the barrell back up, the shell would not come out. So I shot the rifle again. I got the spent case out with a cleaning rod. Now when i try to reload it, I noticed that the extractractor doesn't come all the way out. When I try to load a round the shell snags on the extractor skuffing the case. WHAT IS WRONG?
mrdux is offline  
Old November 22, 2010, 12:50 AM   #2
hoghunting
Senior Member
 
Join Date: March 27, 2006
Posts: 1,353
Are these reloads or re manufactured ammo? If you take the forearm off and remove the barrel, you should be able to push the extractor back and forth. You may need to oil the channel the extractor rides in.
hoghunting is offline  
Old November 22, 2010, 07:48 AM   #3
mrdux
Member
 
Join Date: July 9, 2009
Location: Texas
Posts: 15
I have tried both reload and factory. I apprears that the extractor is not comming out far enough. I have oil it down and will try that.
mrdux is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:31 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06070 seconds with 7 queries