The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old August 12, 2010, 07:06 PM   #1
mwar410
Senior Member
 
Join Date: December 25, 2008
Location: maine
Posts: 234
repair browning a bolt finish?

Is there something out there to repair the hard plastic-like finish on a a-bolt stock? there is a nice gouge from a tree stand, not into the wood, but down to it. He doesn't want to strip the entire stock and refinish.
mwar410 is offline  
Old August 13, 2010, 11:10 AM   #2
SCcdp
Senior Member
 
Join Date: November 29, 2004
Location: South Carolina Lowcountry
Posts: 102
Good luck with that! I absolutely hate those finishes. They look great until you get a ding in them. I've redone the stocks on 3 BAR's and 3 A-Bolts and luckily the owners didn't want them returned to that factory finish. All of them got stripped, checkering recut and rubbed down with numerous coats of tung oil.

And whatever type of finish Browning uses is harder than hell to get off. It really is a shame they do that to the guns because most of the time Browning uses good wood with nice figure.
SCcdp is offline  
Old August 13, 2010, 12:26 PM   #3
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 11,532
Browning uses a catalyzed poly finish on their rifles and shotguns. You can touch it up using Flecto Varathane, build up several coats then sand and polish the patch. It comes pretty close to matching.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
Old August 13, 2010, 07:10 PM   #4
oneoldsap
Senior Member
 
Join Date: September 16, 2009
Location: I live in the foot of the Green Mountains of Vermont
Posts: 1,590
FYI

Should you decide to strip and refinish . Permatex or CRC aerosol gasket remover is the stuff to use . Spray it on , let it bubble up and scrape with a plastic razor blade . Several applications are required as there are several coats on Browning stocks . Does not wet wood or raise the grain . Clean checkering with a soft fine wire brush .
oneoldsap is offline  
Old August 13, 2010, 08:35 PM   #5
mwar410
Senior Member
 
Join Date: December 25, 2008
Location: maine
Posts: 234
yeah, i did a beretta with the same finish. stripped with a heat gun and oiled it. too bad he doesn't want to go that route. I'll try the varathane touch-up
mwar410 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:38 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06137 seconds with 7 queries