The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Thread Tools Search this Thread
Old August 4, 2010, 09:03 AM   #1
Junior Member
Join Date: August 4, 2010
Posts: 1
Help with Stevens Mod. 520

I'm new to The Firing Line, and I am looking for help with a Stevens Mod. 520 12 ga. pump. I have an early model that has an inertia block to release the slide lock when the gun is fired. I have been unable to find any drawings that illustrate this part. I have found an old thread here at TFL from 9/9/2007 that included some great photos of this inertia block. The poster was "jus1derin".

The problem I am having is installing the slide lock spring. This spring is not visible in jus1derin's photos, and I can not figure out how to install it so that the slide lock engages. Can anybody help with either photos or a description of how this spring is installed?
foz937 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:44 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06398 seconds with 9 queries