The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old August 4, 2010, 09:16 PM   #1
celtgun
Senior Member
 
Join Date: August 17, 2008
Location: SE North Carolina
Posts: 197
Aluma Hyde advice

Going to try Aluma Hyde II on 2 rusted guns for the first time.
Any advice/tips would be very appreciated.
What is best to degrease right before spraying?
Thanx.

Pray and Shoot Daily.
Lee Jones(Celtgun)

"The truth is that any good modern rifle is good enough. The determining factor is the man behind the gun." Theodore Roosevelt, 1910
celtgun is offline  
Old August 4, 2010, 10:35 PM   #2
essohbe
Junior member
 
Join Date: March 22, 2009
Location: U.S.A.
Posts: 817
Is it going on steel or aluminum? I ask, because here's my experience with it:

They say prep is everything. I painted a ruger 10|22 reciever in alumihyde black. I sanded and degreased the hell out of it. Got it as perfect as I could, even made sure it dried right. Now, I sprayed it and cured it with a heat gun just like your supposed to. Guess what? As soon as it gets a scratch, it begins to peel off from there. Don't get me wrong, it is touch epoxy paint but man, I expeted a little better for a f%@#!'g $12 can of paint.

I decided to touch up an AK with it also.
No prep except roughing up the anodized steel a bit with fine sandpaper.
Blew the dust off and sprayed. Didn't cure it or anything. To this day it has stayed on the steel AK and it scratched off where the safety selector rubs the reciever but didn't peel like the ruger aluminum reciever....

So, I don't know what to tell you. Blue it if you can, use alumihyde if you must. Apparently the more you care then the less quality you'll get, but when you don't care what happens it will turn out perfect...
essohbe is offline  
Old August 5, 2010, 05:24 AM   #3
oneoldsap
Senior Member
 
Join Date: September 16, 2009
Location: I live in the foot of the Green Mountains of Vermont
Posts: 1,581
The baked on finishes are far superior to Aluma Hyde but require a little more work . Aluma Hyde works fairly well on aluminum if you allow a couple weeks curing time and give the surface some tooth .
oneoldsap is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:21 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06597 seconds with 9 queries