The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old June 13, 2010, 09:21 PM   #1
dennis200
Junior Member
 
Join Date: June 4, 2010
Location: Central Ohio
Posts: 1
colt 1917 ejector dissasembly

I have 2 colts I have apart. They are rusty from water damage. look like they were a titanic artifact. I am down to the ejector spline shaft and ejector push rod. I made these names up. that is the best way to describe it for me. I am told it is left handed and I don't want to have to buy new parts if I break it. Would any one be able to direct me or give advice?
http://i48.tinypic.com/dgmali.jpg
dennis200 is offline  
Old June 14, 2010, 07:01 PM   #2
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,817
These older Colt's require two special tools to disassemble.
Try it without the tools and you'll ruin the ejector and these are factory fitted parts. You can't just buy a used one and expect it to fit. The ejector sets head space and barrel/cylinder gap among other things, and if you damage the original, you're in real trouble.

Even with the tools there is a risk of damaging the assembly.

To disassemble;
Make or buy a special ejector wrench. This is a piece of flat steel about 1/8" thick which is cut out in the center to fit snuggly down over the ratchet in the end of the ejector.
If you're willing to take a big chance of ruining the ejector, some people have used sockets from a socket that will fit over the ratchet snuggly.

Put three EMPTY cartridge cases in the cylinder and put the ejector rod head in a padded vise.
Grip the cylinder and unscrew the ejector from the checkered ejector rod head.

Remove the empty caaes.
Using the wrench, lift the ejector from the cylinder slightly and VERY CAREFULLY unscrew the ejector from the ejector rod. The ejector is RIGHT HAND theads.

Slide the cylinder off the ejector and crane assembly.

Using a special tube wrench, unscrew the ejector bushing from the rear of the crane barrel.

Slide the ejector and spring out of the crane barrel.

You can buy the wrench from Brownell's for small to medium Colt's but I don't know if it will fit the larger New Service.

http://www.brownells.com/.aspx/pid=7...E_BUSHING_TOOL

To reassemble, reverse the process, but be EXTREMELY careful when you start the ejector back onto the ejector rod. These are very easy to cross thread, and if you do, you've ruined it.
Screw the ejector back on slowly until you feel it's getting tight, then turn it far enough for the witness mark and the holes in the ejector to line up with the pins in the cylinder.
Make sure the ejector is fully on and bottoms into the cylinder.
Dfariswheel is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:56 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05872 seconds with 7 queries