The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old May 27, 2010, 08:44 AM   #1
dlb435
Senior Member
 
Join Date: January 26, 2009
Posts: 654
AR-15 front sight

My front sight was pinned on a little off to one side. I've got to re-pin the thing. What size reamer do I need for the over size pins?
dlb435 is offline  
Old May 28, 2010, 04:00 AM   #2
ogree
Senior Member
 
Join Date: January 18, 2005
Location: Idaho
Posts: 146
The size of the reamer would be determined by the size and kind of the pins you are using.
I had to do that once, welded up the original holes, aligned the front sight and then re-drilled them using the front sight base as a guide....what a pain in the a** that was cause I didn't have a fixture specifically made for performing that operation.
If possible....I would send it back to the manufacturer and have them correct it, that is less of a hassle.
ogree is offline  
Old May 28, 2010, 06:37 AM   #3
dlb435
Senior Member
 
Join Date: January 26, 2009
Posts: 654
I've ordered a size 2/0 reamer and some oversize pins. Doesn't look like it will be much of a job. The original pins were 0.125 straight pins.
dlb435 is offline  
Old May 28, 2010, 01:09 PM   #4
LongRifles, Inc.
Senior Member
 
Join Date: October 21, 2009
Location: Black Hills of S. Dakota
Posts: 195
Here's a trick used by the USMC PWS shop and by the better NRA service rifle builders.

Don't pin it. Drill and tap the holes in the front sight assy for set screws.

Set your rear site to MZ (mechanical zero) and then adjust the front base till it times up and shoots a no wind zero right down the pipe.

Good luck.
__________________
LongRifles, Inc.
"More than a business,
This is a lifestyle."

www.longriflesinc.com
LongRifles, Inc. is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:37 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05771 seconds with 7 queries