The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 29, 2010, 05:54 PM   #1
MO. Shootin
Senior Member
 
Join Date: February 23, 2010
Posts: 203
flashhole deburring for a 204?

I got the Precision reloading shooting guide and have read a lot about flashhole deburring along with other case prep processes.

I have not been able to find a tool for my 204 for flashhole deburring.
Any help would be appreciated.
MO. Shootin is offline  
Old March 29, 2010, 06:05 PM   #2
uncyboo
Senior Member
 
Join Date: November 7, 2008
Location: Shelby, MT
Posts: 1,013
I used the RCBS tool and took a 22 pilot and turned it around backwards. Case mouth just rested on the flat part. Worked OK. I heard LE Wilson makes one but haven't been able to find any.
uncyboo is offline  
Old March 29, 2010, 08:00 PM   #3
Toddco
Senior Member
 
Join Date: August 7, 2009
Location: Stony Plain, Alberta
Posts: 101
.204 flash hole

I put some electrical tape over the shaft of mine to take up the slack, worked just fine. You only have to use minimal pressure to get the burrs off of new brass.
Toddco is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:27 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05625 seconds with 7 queries