|March 19, 2010, 11:18 AM||#1|
Join Date: April 11, 2009
Location: Orange County, Ca
Ring Height Question
Im looking to buy Badger Ordnance - USMC M40A3 Rings .886 30mm w/1 inch inserts $203.
Badger Ordnance 30mm Rings, USMC M40A3 .886" High
For a Remington 700 SPS tactical 308 win.
Badger Alloy Base306-06A Rem 700 (SA) 20MOA
With a Bushnell 3200 tactical.
Im looking to get as low as I can with the scope for the tightest cheek weld I can get or close.
This is my goal for scope height or +.5 of an inch higher than that. Will these fit the job or what size/model rings do I need to get?
Bullet placement over bullet wastement
|March 19, 2010, 04:34 PM||#2|
Join Date: June 25, 2008
Location: Central, Southern NY, USA
Well, doing a little math....
If you've got the 42mm version and allow and extra 2mm for the body (a guess) then you have 1.7322 inches, divided by 2 you've got .86614 inches from the center of the scope to the outer edge. That would leave you with .0198 inches without considering barrel taper.
Still happily answering to the call-sign Peetza.
The problem, as you so eloquently put it, is choice.
You do not HAVE a soul. You ARE a soul. You HAVE a body.
He is no fool who gives what he can not keep to gain what he can not lose.
-Jim Eliott, paraphrasing Philip Henry.