The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 3, 2010, 04:37 PM   #1
sophijo
Senior Member
 
Join Date: June 28, 2004
Posts: 664
S&W 617 .22LR 10 shot

It's very difficult to extract the fired casings from this cyclinder. Unfired cartridges will slide out easily. Once fired the cases must expand in the cyclinder because they are impossible to eject one handed. All ten chambers hold tight to fired cases and will release unfired cartridges easily. Should I polish each chamber? If so I'd appreciate guidence on how best to do that.
sophijo is offline  
Old March 3, 2010, 06:28 PM   #2
Doyle
Senior Member
 
Join Date: June 20, 2007
Location: Starkville, MS
Posts: 4,979
I don't see how polishing would hurt. Just don't get too aggressive with the polishing compound.
Doyle is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06640 seconds with 7 queries