The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Curios and Relics

Reply
 
Thread Tools
Old January 9, 2010, 05:29 PM   #1
Headgear
Senior Member
 
Join Date: December 1, 2008
Location: Southeast, IN
Posts: 123
Old M1, modern ammo?

My brother and I are going to take a trip up to Camp Perry in a couple of weeks and pick out a couple of Garands. (Hell Ya!!!) Sorry I'm a little excited.

Is it safe to shoot modern 30-06 ammo in them? I would not want to run old corrosive ammo though it. If not, could I roll my own and tone them down to a safe level?

Thanks
David
Headgear is offline  
Old January 9, 2010, 06:08 PM   #2
Chipperman
Senior Member
 
Join Date: January 31, 2000
Location: Live Free or Die, Baby!
Posts: 1,429
The general consensus is that modern .30-06 ammo will possibly bend the op rod on a Garand. You can remedy this by chanding the gas plug or shooting surplus ammo.
Chipperman is offline  
Old January 9, 2010, 06:14 PM   #3
Tom2
Senior Member
 
Join Date: June 23, 2004
Location: Ohio
Posts: 5,648
Federal or someone is coming out with a load for Garands that does not exceed the milspecs. There is plenty of ammo around for them. If the CMP still is selling the Greek ammo in clips, that might be a good start for now. I think most of the white box ball ammo from the US makers in the past has been compatible, as it is not bumped up in power for hunting. You could also see what people are using, on the CMP forums. You can load your own ammo too. Just be aware of the QC you must adhere to for ammo used in semiautos versus bolt guns. Like no high primers, maybe mil spec primers, probably full length resizing, OAL, powder charges, etc.
__________________
Your gun is like your nose, it is just wrong for someone else to pick it for you!
Tom2 is offline  
Old January 10, 2010, 09:27 AM   #4
Chris_B
Senior Member
 
Join Date: February 9, 2007
Posts: 2,841
Quote:
Is it safe to shoot modern 30-06 ammo in them? I would not want to run old corrosive ammo though it. If not, could I roll my own and tone them down to a safe level?
Not all "M2 ball" 30-06 ammunition is corrosive primer. Just an FYI Easiest solution is the adjustable gas plug, if you're worried about using modern ammo. Do your tweaking before Camp Perry though

...but ain't all M1 rifles old?
Chris_B is offline  
Old January 10, 2010, 03:50 PM   #5
velocette
Senior Member
 
Join Date: May 25, 2007
Location: South Florida
Posts: 834
Federal's 30-06 ammo for the Garand:

http://www.midwayusa.com/viewProduct...tNumber=112253
__________________
Trigger control + Breath control + Sight alignment = Gun Control.
http://www.hrpclub.info/
NRA Smallbore Prone Master
velocette is offline  
Old January 17, 2010, 11:48 AM   #6
Orlando
Senior Member
 
Join Date: May 2, 2009
Posts: 253
You can run any good quality commercial ammo under 180 gr bullet if you use a adjustable gas screw. No commercial ammo without it unless specifically designed for the Garand
Federal and Hornady both make a commercial Garand specific load but priciy
While CMP is currently out of mail order surplus ammo ,small quanities are available at the stores
Orlando is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:54 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07151 seconds with 7 queries