The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 4, 2010, 10:32 AM   #1
JH1
Member
 
Join Date: August 25, 2005
Posts: 91
Marlin 917v Problem

I just got a marlin 917v on a trade. At first it was doing ok then misfired about once every mag, now wont fire at all. Shot about 25 rounds total. When you load it up and pull the trigger, the gun snaps and the firing pin hits the primer, but wont fire. Went through two full mags with no shots fired. Also, it feels like the bolt is hard to close and open, dont know if this is just because of the firing pin snapping and round not firing or what.
JH1 is offline  
Old January 4, 2010, 02:26 PM   #2
TriumphGuy
Senior Member
 
Join Date: October 5, 2009
Posts: 559
Sounds like a bad firing pin/spring.
TriumphGuy is offline  
Old January 7, 2010, 04:58 PM   #3
UniversalFrost
Senior Member
 
Join Date: February 20, 2006
Location: West Virginia
Posts: 2,298
you made sure that the bolt was closing? you clean and inspect the bolt, trigger, etc...? you tried different ammo?

you called marlin yet?
__________________
Lifetime member VFW and NRA

"Quando Omni Flunkus Moritati" (when all else fails play dead) -Red Green

UniversalFrost is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:23 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06079 seconds with 7 queries