The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 24, 2009, 03:39 PM   #1
dyl
Senior Member
 
Join Date: October 31, 2009
Location: Virginia
Posts: 509
remove firing pin, Bernardelli P0-18?

Hey guys,

I think I may need to replace a firing pin spring on a Bernardelli P0-18. It'd be nice to see for myself by looking at the spring. Anyone know how to do it?

I'm having a lot of trouble getting this thing out. There's no backplate, just a plunger and little hole about a cm towards the muzzle. There doesn't seem to be a respective hole on the top side of the slide if that little hole contains a pin.

I've tried to look up how to remove firing pins but all I get on the 'net are ones with backplates and the cz52 (wish it were that easy, just push plunger)

I hope I don't have to remove the pin that holds the back sights on but I might. Any ideas? - thanks in advance.
dyl is offline  
Old November 24, 2009, 10:42 PM   #2
dyl
Senior Member
 
Join Date: October 31, 2009
Location: Virginia
Posts: 509
Haven't made much progress, but I now think the problem for me is removing the "firing pin stop pin" if I read it correctly. Found an old diagram for a Bernardelli VP (not my model) but it should be related.
dyl is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:53 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05345 seconds with 7 queries