The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Curios and Relics

Reply
 
Thread Tools
Old December 2, 2009, 06:45 PM   #51
rr2241tx
Senior Member
 
Join Date: August 2, 2007
Location: The Great State of Taxes
Posts: 260
Luger. You only need to be faster than your buddy, not faster than the bear.
__________________
rr2241tx
rr2241tx is offline  
Old December 6, 2009, 08:49 PM   #52
Ignition Override
Senior Member
 
Join Date: February 18, 2008
Posts: 1,773
Tiki:

Just where does a hunter try to hit a water buffalo, or grizzly bear?
Would it be the neck or chest, assuming that the skull is too thick?

rr2241tx:

But maybe he has the truck keys in his pocket.
Ignition Override is offline  
Old December 7, 2009, 01:52 AM   #53
Three44s
Member
 
Join Date: December 15, 2008
Posts: 87
M38 Mosin

(M1917 Gov. if you had not outed the .30-06)



Three 44s
Three44s is offline  
Old December 7, 2009, 02:02 AM   #54
Eghad
Senior Member
 
Join Date: May 28, 2005
Location: Texas
Posts: 6,231
How about this..... The M1 updated....

http://www.gokart.net/shop-utopia/mc...458garand.html
__________________
Have a nice day at the range

NRA Life Member
Eghad is offline  
Old December 7, 2009, 09:23 PM   #55
10-96
Senior Member
 
Join Date: October 19, 2005
Location: Tx Panhandle Territory
Posts: 3,123
Ah-Ha! All is not lost, I'm pitching my vote for the 1903 Springfield chambered for the original .30-03, which didn't hang around all that long.
__________________
Rednecks... Keeping the woods critter-free since March 2, 1836. (TX Independence Day)

I'm going to use the words "clip" and "Long Colt" every chance I get. It grinds my gears to see new members attacked when we all know dang good and well what's being refered to.
10-96 is offline  
Old December 8, 2009, 07:59 AM   #56
mapsjanhere
Senior Member
 
Join Date: August 6, 2009
Location: Albuquerque
Posts: 2,342
Mauser 98k, reamed for 8x64 (Brenneke's answer to the 30-06).
__________________
F 135 - the right choice
mapsjanhere is offline  
Old December 9, 2009, 08:03 AM   #57
Erfurter1937
Junior Member
 
Join Date: September 3, 2009
Location: PA
Posts: 10
Mauser 98K

I would use the mauser 98k with 8mm. It's really that simple....
Erfurter1937 is offline  
Old December 9, 2009, 09:02 AM   #58
jaguarxk120
Senior Member
 
Join Date: February 28, 2008
Location: Michigan
Posts: 1,928
The 55cal. Boyes anti tank rifle should do the job!
jaguarxk120 is offline  
Old December 10, 2009, 09:57 PM   #59
pvt.Long
Senior Member
 
Join Date: March 7, 2009
Posts: 433
i vote for the 55 Boyes and the 1903 springfield the enfield smle and the m1 garand
pvt.Long is offline  
Old December 11, 2009, 05:09 AM   #60
Moloch
Senior Member
 
Join Date: November 27, 2005
Posts: 1,304
Gewehr 98!

Most powerful of the milsurps (8mm bullet 196 grain @ 2700 with great sectional density), good accuracy, and if you run out of ammo you can poke the bear from a safe distance with the 29'' long barrel.
Moloch is offline  
Old December 15, 2009, 10:41 PM   #61
jabojerry
Junior Member
 
Join Date: November 30, 2007
Location: mid-Michigan
Posts: 3
An 8mm Model 98 Mauser will do anything a 30-06 will do if hand loaded properly. 2,700 fps with premium 165 to 180 grain projectiles will preform excellent for you on a bear. Most commercial 8mm bullets are sold to fire in the pre 1912(?) barrels which are smaller than the WWII Mausers. The muzzel velocity for most commercial 8mm's are in the 2,200 to 2,350 fps area. Not fast enough for longer, accurate shots orgood expansion with many projectiles.
jabojerry is offline  
Old December 23, 2009, 02:58 PM   #62
Gator_Weiss
Member
 
Join Date: December 12, 2009
Location: Southwestern USA
Posts: 40
Get yourself a decent K98 loaded with 8MM JS rounds in a softpoint

Get yourself a decent K98 loaded with 8MM handloads that duplicate the JS loadings or beyond.

In your cartridge bag, throw in a few 8mm RNSP rounds if you intend to shoot at ranges under 150 yards. Only put one RNSP in the rifle - in the chamber - because they may not feed well from the magazine like the spire points.

Do not use factory loaded 8mm mauser rounds, unless you special order from those vendors that sell them in the JS range. Most of the factory loaded 8mm is loaded down for safety in pressures. It works well for white tail deer, but I sure as hell wouldnt snipe away at a brown bear with it. You would probably wound him and who knows what happens after that?

Though it is not reccommended, Elephants have been killed with 8mm Mauser loading a solid bullet and firing into the brain. Cape Buffalo, Rhino, Hippo, have all been taken repeatedly with the 8mm Mauser. Read your history on South African hunting. Often only .303 and 8mm Mauser were all that were available in the old days down there.

The 8mm Mauser case has plenty of room in it for heavy loading. Plenty of room for your powder charges in that bottle. Bullets weighing anything at or over 180 grains will work for the project. Personally, I would load something in the way of the 220grn JSP. Place your shots carefully, and take them only under conditions where you KNOW you are going to connect well. You will get your bear. Just do it at a moderate range under good shooting conditions.

***************************************************************************
NOTES / CUT-N-PASTE - 8MM ORIGINAL LOADINGS FROM WW-2 (This was not written by me)

Then I learned two things. Number one was Norma currently loads the 8mm Mauser with a 196-grain bullet at 2,500 fps, and number two was such was pretty much what a "standard" WWII load should be. In the beginning duplicating such wasn't so easy. American ammunition makers feared their factory loads might be fired in the old .318" barrels of pre-1905 8mm Mausers instead of thereafter standard .323" barrels. Therefore they load this cartridge only to about 35,000 psi. Good condition Mauser 98 actions can easily accommodate 50,000 psi. I discussed this with powder and bullet company ballisticians and then carefully developed a good full-power 8mm load closely approximating WWII military ballistics. It consists of the 195-grain Hornady Spire Point bullet over 48 grains of Hodgdon Varget powder for an average velocity of 2,480 fps from this particular rifle. (By the way, that normal 8mm factory load clocks 2,393 fps.)
Handloads Rule

When that handload was fired from my VZ24 sniper rifle, groups now stayed under two MOA on paper targets at both 100 and 200 yards, and also the bullet's trajectory closely followed the settings of the old scope. For our mutual birthday every year, I spend a week with Clint Smith, shooting and having fun.

************************************************************************
ANOTHER CUT-N-PASTE THIS WAS NOT WRITTEN BY ME:

The 8x57JS (8mm Mauser) By Chuck Hawks

Here are some cartridge specifications of interest to 8x57JS reloaders: bullet diameter .323", maximum COL 3.228", maximum case length 2.244", SAAMI MAP 37,000 cup.

Bullets from 125 to 220 grains are available, but the most popular are those between 150-200 grains.

Medium burning rifle powders are generally the most successful in the 8x57, including VARGET, H335, H380, H414, H4350, IMR 4064, IMR 4350, W748, and VIHT N-150.

Bullet / Wgt / Dia. Powder Powder Weight MV Primer
Speer 200gr .323 IMR 4064 42.0 2198 CCI-200
Speer 200gr .323 IMR 4064 46.0 2434 CCI-200
Speer 170gr .323 IMR 4064 45.0 2509 CCI-200
Speer 170gr .323 IMR 4064 49.0 2723 CCI-200
Speer 150gr .323 IMR 4064 47.0 2695 CCI-200
Speer 150gr .323 IMR 4064 51.0 2915 CCI-200

Last edited by Gator_Weiss; December 23, 2009 at 03:07 PM.
Gator_Weiss is offline  
Old December 24, 2009, 07:42 AM   #63
Tamara
Moderator Emeritus
 
Join Date: March 11, 2000
Location: Indianapolis, IN
Posts: 15,930
Quote:
Originally Posted by TikiRocker
For me a No5 Mk1 - The 303 has taken all of Africa's big 5 game and has taken just about every kind of game on earth since the 1900's.
Sure, you can take the Big 5 with a .303. You can free-climb El Capitan or ride motorcycles naked, too. Just because you can do something doesn't necessarily make it a good idea.
__________________
MOLON LABE!
2% Unobtainium, 98% Hypetanium.
The Arms Room: An Online Museum.
Tamara is offline  
Old December 24, 2009, 07:52 AM   #64
earlthegoat2
Senior Member
 
Join Date: March 20, 2009
Location: Lowcountry
Posts: 373
I dont see why Garand rifle would not be a stellar choice. Oh wait, just reread original post.

I though it was just about rebarrelling to 30-06.

Why not an M14 then. 20 rounds of rip roaring 308. Maybe not so many of these Milsurps around.
__________________
I say take off the warning labels and let them sort themselves out.
earlthegoat2 is offline  
Old December 24, 2009, 08:06 AM   #65
Tamara
Moderator Emeritus
 
Join Date: March 11, 2000
Location: Indianapolis, IN
Posts: 15,930
Quote:
Originally Posted by earlthegoat2
Why not an M14 then. 20 rounds of rip roaring 308. Maybe not so many of these Milsurps around.
Because the thread specifies "bolt gun".

Out of stuff I actually have, I don't know which I'd pick. Something short and light, with as much sectional density as possible... My Steyr-Mannlicher only has military ball ammo at the moment. I do have some heavy bullet loads in 7x57 lying about, and the Venezuelan FN carbine is a handy little piece...
__________________
MOLON LABE!
2% Unobtainium, 98% Hypetanium.
The Arms Room: An Online Museum.
Tamara is offline  
Old December 24, 2009, 08:07 PM   #66
mnw42
Senior Member
 
Join Date: March 3, 2008
Location: Bucks Co., PA
Posts: 210
J.P. Sauer & Sohn M30 Luftwaffe survival drilling 2x 12 ga 2.5" over 1x 9.3x74mmR. I'd have Sauer lengthen the shotgun chambers to accept 2.75" shells.

Hey, a guy can dream... can't he
mnw42 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:24 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.10792 seconds with 7 queries