The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old November 3, 2009, 11:25 AM   #1
Carolina Cowboy
Member
 
Join Date: October 9, 2009
Posts: 21
BP Conversion

I know I am most likely asking a question that has been asked a lot, but could someone point me in the direction to convert my 1860 Uberti Army Colts to shoot BP cartridges, I have no tools so would want to either order the parts, or send them off to have it done. It is for shooting at Cowboy shooting events only. Any help would be much appreciated.
Thanks
Carolina Cowboy is offline  
Old November 3, 2009, 11:40 AM   #2
Oldfalguy
Senior Member
 
Join Date: January 25, 2009
Location: Central Texas
Posts: 126
Carolina
First look at the cylinders available for your particular pistol-
Krist Konverter or R&D
They will have ones for either the Uberti or Peitta 1860-
There are a couple of differences so read about them-
When I bought mine I went with the Krist and a loading ring so I would not have to remove the wedge to load the cylinder with cartridges.
It can be done with a Dremel tool I suppose but I had mine fitted by a pro.
ONce you get that far drop the forum a line and I am sure someone can help you find a gunsmith to fit it for you in your area.
Oldfalguy is offline  
Old November 3, 2009, 12:26 PM   #3
Carolina Cowboy
Member
 
Join Date: October 9, 2009
Posts: 21
Thanks

I went and checked those two out, looks like Kirst is going to be the way I go. Thanks a lot. Am adding that to my Christmas List as we speak. May have to shoot the old fashion way until I save a little more money to purchase the cylinders and ejector system. But looks like the best option for me.
Carolina Cowboy is offline  
Old November 3, 2009, 11:38 PM   #4
Newton24b
Junior member
 
Join Date: February 10, 2009
Posts: 974
not sure if you have investigated what a gunsmith would charge you to do the metal removal on the recoil shield, but it may be as much as what the conversion cylinder will cost you.
Just something to investigate before you make an actual purchase of a cylinder system.
Newton24b is offline  
Old November 3, 2009, 11:53 PM   #5
edsmith
Junior Member
 
Join Date: October 31, 2009
Location: Standish,Maine
Posts: 3
do the metal removal your self,all you need is a dremel,the 5/8 course sanding drum,it will take about 2 hours,I just installed one on my pieta 1858 rem.if you don't have dremel,it is a good excuse to get one.
edsmith is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:39 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06493 seconds with 7 queries