The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old September 27, 2009, 06:55 AM   #1
Bella
Member
 
Join Date: July 6, 2009
Posts: 83
Auto Cleaning?

I have a question for those of you that shoot semi-auto shotguns. How often do you clean it? Asking auto owners around here I have gotten answers that range from every time the guns is used to once a year. The once a year guy shoots every weekend at our trap club. He says that his gun works as well as the ones that are cleaned all the time.

How often do you guys clean your self-loaders?
Bella is offline  
Old September 27, 2009, 08:46 AM   #2
hogdogs
Staff In Memoriam
 
Join Date: October 31, 2007
Location: Western Florida panhandle
Posts: 11,071
You will be asked what model by those that use auto as gas and inertia guns are totally different.
And you will still get a wide variety of answers...
Brent
hogdogs is offline  
Old September 27, 2009, 12:22 PM   #3
RNB65
Senior Member
 
Join Date: October 17, 2006
Location: Richmond, VA
Posts: 167
I clay shoot with a Beretta 391. I wipe down the gas cylinder and inside of the receiver with BF CLP after each range trip to clean off the worst of the residue and keep it lightly lubed. Then wipe down the outside. 3 minutes max and I'm done. I only clean the barrel about once a year. Never have any problems.
__________________
THR refugee.
RNB65 is offline  
Old September 27, 2009, 12:23 PM   #4
bentley998
Junior Member
 
Join Date: April 30, 2009
Posts: 12
Cleaning auto shotguns

My Rem 1100 - gas operated 2 boxes/week & known to be sensitive to cleaning - brush the barrel, cleaning magazine tube, check the gas port, condition of the o-ring - after firing -have had one failure to eject in more than 500 rounds with reloads - probably a problem with the reload rather than the gun

Browning A-5 -long recoil operated -between seldom and rarely although this gun is not much used at present
bentley998 is offline  
Old September 27, 2009, 02:56 PM   #5
squeak003
Member
 
Join Date: August 20, 2008
Location: michigan
Posts: 98
sagia-20. when i first got it to get all off the grease off of it......since then.....never.....
__________________
Mosin Nagant M91, Mosberg 500 12g, ruger 10/22 with a few mods, saiga 20 with a red dot (soon to be converted)
will be looking to add to my collection soon (most likely a sig p232)
squeak003 is offline  
Old September 28, 2009, 06:47 AM   #6
oneounceload
Junior member
 
Join Date: April 18, 2008
Location: N. Central Florida
Posts: 8,518
I own an 1100 - if it is not cleaned regularly, it will start to get gunked up and slow down to the point the action does not cycle properly
oneounceload is offline  
Old September 28, 2009, 12:00 PM   #7
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 11,303
I shoot a Benelli - so its an inertia gun.....and it would probably continue to cycle for many thousands of shells ...but my answer is the same so the type of gun doesn't matter. I clean it every time I shoot it.

Grime and gunk inside a shotgun that builds up is not going to do anything except increase wear. What's the point of shooting it until it quits cycling ...unless you just want to wear out a gun prematurely ???
BigJimP is offline  
Old October 2, 2009, 06:18 PM   #8
shortwave
Senior Member
 
Join Date: December 17, 2007
Location: SOUTHEAST, OHIO
Posts: 5,931
I`m with BigJimP. I clean mine after every outing.
shortwave is offline  
Old October 2, 2009, 06:19 PM   #9
dondavis3
Senior Member
 
Join Date: August 20, 2009
Location: Dallas / Fort Worth Area
Posts: 671
I should and try to clean after every visit to the range or hunting, but I don't always do it.

If hunting and it's wet at all - I always clean & oil well.
__________________
Don Davis

Last edited by dondavis3; October 2, 2009 at 06:26 PM.
dondavis3 is offline  
Old October 2, 2009, 06:30 PM   #10
JWT
Senior Member
 
Join Date: March 16, 2007
Location: Tucson, AZ
Posts: 3,126
All my guns get cleaned after every use. Cleaning them won't hurt them, not cleaning them could have negative affects over time.
JWT is offline  
Old October 2, 2009, 07:03 PM   #11
pinetree
Senior Member
 
Join Date: March 5, 2001
Location: Cumming GA
Posts: 625
Beretta 390 here. 12 years old. I will wipe it down doing a field break down about every outing - more for rust than anything else. I do a deep clean once a year or so. A tip a learned re: AR's with mineral spirits and clp is awesome for getting off caked on carbon from my ported choke tube.

I shoot about a case in the dove field and a case upland and a case waterfowling and 2 cases with trap charity shoots and sporting clays a year in my auto.

I clean it as much at I would a pump. My OU is simpler but that third shot is important in the goose field or duck pond. Nothing like a triple of mallards.

I have only dropped my trigger group out once and even then only a wipe down and a blow out. I've only taken the bolt apart once.

My rib is bent and much of the bluing gone - duck and goose hunting is tough on a gun. But, it is 100%.

I love my gun proven in the field and on the course.
pinetree is offline  
Old October 2, 2009, 07:35 PM   #12
oneounceload
Junior member
 
Join Date: April 18, 2008
Location: N. Central Florida
Posts: 8,518
Not cleaning it can result in residues left inside that could have some consequences if left unchecked. Secondly, you need to clean your choke tube, otherwise the plastic residue will build up enough to alter your choke constrictions. Also, your choke tube needs to have the threads cleaned and regreased regularly, or the choke can seize inside
oneounceload is offline  
Old October 2, 2009, 09:47 PM   #13
DWARREN123
Senior Member
 
Join Date: January 22, 2006
Location: BETWEEN TN & KY
Posts: 1,759
Depends on your gun. Some needs lots of cleaning while some don't. Experiment and see how long yours will go without cleaning. Might surprise you.
__________________
Have a nice day!
DWARREN123 is offline  
Old October 3, 2009, 03:06 PM   #14
LanceOregon
Junior member
 
Join Date: May 10, 2008
Location: Oregon
Posts: 2,774
Slip 2000 Gas Piston Parts and Choke Tube Cleaner is wonderful for cleaning both choke tubes and Gas Pistons, typically the two things that get super dirty. Just put them in the jar, wait a few minutes, and they come our sparking clean.






For everything else on my shotgun, I use Shooter's Choice Shotgun and Choke Tube Cleaner. This just eats Carbon build-up alive:





Finally, I use a few sparing drops for Slip 2000 gun lubricant for lubrication.

LanceOregon is offline  
Old October 3, 2009, 08:07 PM   #15
krimmie
Senior Member
 
Join Date: February 11, 2007
Location: S. Florida
Posts: 165
That was like a mini infomercial! Where do I buy?
krimmie is offline  
Old October 5, 2009, 07:38 AM   #16
LanceOregon
Junior member
 
Join Date: May 10, 2008
Location: Oregon
Posts: 2,774
A lot of leading firearms products websites carry these products, if your local gun stores don't have them.

Places like:

midwayusa.com

dillionprecision.com

brownells.com

natchezss.com


--
LanceOregon is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.09010 seconds with 7 queries