The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Reply
 
Thread Tools
Old September 7, 2009, 02:03 AM   #1
mikeu
Junior Member
 
Join Date: September 7, 2009
Posts: 2
H&R Model 950 Single Action Revolver Owner's Manual Needed

I am looking for an owner's manual for an H&R model 950 single action revolver .22 cal or related revolver.
mikeu is offline  
Old September 7, 2009, 08:19 AM   #2
jamesjo
Senior Member
 
Join Date: August 23, 2007
Location: Nebraska
Posts: 195
Mikeu,
I have a model 949, which is the same as the 950 except the 949 is blue instead of nickel. I am sure I have the owners sheet for it. I would be happy to scan it and send it to you. My 949 is a 1980 piece. do you know what year your 950 was produced? It shouldn't make alot of difference, as there were not too many changes in the model through the years.
Also the owners sheet is VERY general, no technical info, just care, cleaning, sighting, loading info. It is a 1 page sheet, printed on both sides. Not much to it, but still nice to have, I will dig the box out and make sure I have it.
Jim
p,s, I just noticed, you mentioned the 950 is a single action revolver. It is actually a double action piece. Email me or Pm me your email addess, and I will send it to you

Last edited by jamesjo; September 7, 2009 at 10:55 AM.
jamesjo is offline  
Old September 7, 2009, 11:15 AM   #3
mikeu
Junior Member
 
Join Date: September 7, 2009
Posts: 2
H&R 940 Revolver Manual

Thanks for the offer! If you can e-mail a copy to me that would be great.

I am trying to figure out if it is supposed to have a "reloading" notch that holds the hammer open while your rotate the cylinder for loading and unloading.

uhrik1@aol.com
mikeu is offline  
Old September 7, 2009, 07:01 PM   #4
jamesjo
Senior Member
 
Join Date: August 23, 2007
Location: Nebraska
Posts: 195
Mike,
You have mail!
I sent the email before I read your post, so I missed answering.
Unless there is a problem with the revolver, you just put the hammer in half cock position. This should allow the cylinder to free wheel for loading thru the loading gate.
Best
Jim
jamesjo is offline  
Reply

Tags
950 , h&r , manual , revolver

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:53 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06640 seconds with 7 queries