The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 4, 2009, 08:43 PM   #1
bcarver
Senior Member
 
Join Date: February 22, 2007
Location: Jackson,Mississippi
Posts: 836
Roll pin holders for AR build

I am building a couple AR lowers. They have two roll pins one in the trigger guard and one in the bolt release. Roll pin holders cost 14 bucks so I don't want to order the wrong size.
Does anyone know the size on these?
bcarver is offline  
Old September 4, 2009, 09:05 PM   #2
madcratebuilder
Senior Member
 
Join Date: November 2, 2007
Location: Northern Orygun
Posts: 4,869
Low cost pin punches.
http://www.midwayusa.com/viewproduct...tnumber=694883

I have used this set on many AR's.
http://www.midwayusa.com/viewproduct...tnumber=191653
madcratebuilder is offline  
Old September 5, 2009, 05:52 PM   #3
bcarver
Senior Member
 
Join Date: February 22, 2007
Location: Jackson,Mississippi
Posts: 836
thanks

thanks
bcarver is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:46 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06148 seconds with 7 queries