The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old March 25, 2009, 09:46 AM   #1
tpcollins
Senior Member
 
Join Date: February 18, 2009
Location: SE Michigan
Posts: 443
Question about the Caldwell Rock rest.

When adjusting for verticle height, is the hole in the base threaded (everything above above it has to be loosened) or does the column just slide up and down (with a keyway) from turning the lower wheel? Thanks.
__________________
What direction did that last shot at Kennedy come from?
tpcollins is offline  
Old March 25, 2009, 10:55 PM   #2
TheTinMan
Senior Member
 
Join Date: December 8, 2008
Posts: 102
Had to read your question a couple of times, but think I got it now. The post is threaded with a slot for the locking key. The hole is the base is smooth. You adjust the height with the wheel.
TheTinMan is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:57 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05187 seconds with 7 queries