The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 25, 2009, 12:19 AM   #1
Brian Dukes
Junior Member
 
Join Date: March 12, 2006
Posts: 7
Stubborn Pin

I'm trying to get an action apart on an older Remington Woodmaster semi auto, and I'm having trouble getting the 3/32" drift pin out of the operating handle. I've already broke a 1/16" punch and bent another; I'm trying to soak some oil in. I'm affraid to whack it too hard becuase the pin is in the bolt, which is floating in the action, and probably shouldn't be subject to too much abuse.

Any suggestions?

Last edited by Brian Dukes; March 25, 2009 at 12:38 AM.
Brian Dukes is offline  
Old March 25, 2009, 02:30 AM   #2
sadsack
Senior Member
 
Join Date: February 4, 2006
Posts: 206
Brian: Are you driving it from the top down? You'll not have to worry about damage to the action by driving the pin out.


(edit) 3/32 punch would be better.

Last edited by sadsack; March 25, 2009 at 02:38 AM.
sadsack is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:34 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05642 seconds with 7 queries