The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 13, 2009, 01:45 PM   #1
dosta43
Junior Member
 
Join Date: March 13, 2009
Location: Charlottesville, VA
Posts: 2
Broomhandle extractor late model

I finally found one; now, how to install? Do I need a gunsmith, or can I do it myself?

Thanks
dosta43 is offline  
Old March 13, 2009, 01:59 PM   #2
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,649
The broomhandle extractor is its own spring. To remove, use a screwdriver to push up behind the front hook, while pulling forward out of engagement with the bolt. It is in this step that extractors are often broken which is why most folks will advise against removal unless necessary. If the hook is broken off, it may be necessary to lift the front end with a small screwdriver while pushing the back or the "wings" with another screwdriver or punch.

To install, bring the extractor back as far as possible and hook it under the lips in the bolt. Then hold the rear end down while lifting up on the front, and slip the extractor back into its slot.

Note, some of the extractors on the market are castings and may be more brittle than the originals, so extreme care is called for.

Jim
__________________
Jim K
James K is offline  
Old March 13, 2009, 08:51 PM   #3
dosta43
Junior Member
 
Join Date: March 13, 2009
Location: Charlottesville, VA
Posts: 2
Thanks, Jim--I shall get me to a gunsmith asap.
dosta43 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:17 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05889 seconds with 7 queries