January 31, 2009, 01:32 PM | #1 |
Junior Member
Join Date: January 31, 2009
Posts: 1
|
BPS 10ga ?
Hello just have a quick question. I recently bought a BPS 10ga NWTF edition 24'' barrel and noticed that the forcing cone is very short and I was suprised at this because I shot a Rem 870 3.5 before this and the forcing cone was lengthened from the factory. Would I benefit if I had it leghtened and polished in the BPS or is there a reason it's not done? Any help in appreciated
|
February 2, 2009, 07:04 PM | #2 |
Senior Member
Join Date: February 22, 2007
Location: Jackson,Mississippi
Posts: 838
|
Maybe...
The only reason I could concieve for a required short forcing cone would be pressure need to operate an auto shotgun.
The shorter forcing cone could create more pressure. On a pump I can't think of a reason. Are you going to do the work yourself? I had Gobbleguns in Batesville,AR lengthen the forcing cone in a 10 gauge. They were the first person I found who would/could do 10 gauge. They did a great job.(also ported the barrel) |
Thread Tools | Search this Thread |
|
|