The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 1, 2009, 05:45 PM   #1
shepherddogs
Senior Member
 
Join Date: January 9, 2007
Posts: 1,007
Model 67 Cylinder Binding

I bought an early model S&W 67 with the stainless sights. After about 3 cylinders of wadcutters the cylinder started binding. I looked and couldn't see anything that would cause this. So I cleaned it real well in Hoppes #9 and the problem seems to have disappeared. It seems like I recall some Smiths having a problem like this years ago. Can anyone shed some light on this? And Happy New Year!
shepherddogs is offline  
Old January 1, 2009, 08:23 PM   #2
Harry Bonar
Senior Member
 
Join Date: December 5, 2004
Location: In the Vincent, Ohio general area.
Posts: 1,804
S&W

Sir;
Check the barrel cylinder gap, endshake of the cylinder, the dirt under the "star" at rear of cylonder and if any are not right send it to a real "expert" S&W smith.
Harry B.
Harry Bonar is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:19 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05686 seconds with 7 queries