The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Competition Shooting

Reply
 
Thread Tools
Old December 8, 2008, 03:55 PM   #1
keys85
Junior member
 
Join Date: September 20, 2008
Posts: 199
AR-15 Match Rifle

I have one of those lead wedge weights in the stock of my match rifle, I trimmed it to balance at the delta ring. I am curious to where most shooters balance their rifle. Do many shooters make their rifles slightly muzzle heavy or generally keep it balanced right at the delta ring? I prefer a slightly heavy muzzle for stability and control, therefore was thinking of trimming my weight just a hair more.

Balance @ delta ring where it meets up w/ receiver versus center of delta ring versus foward of delta ring at the start of handgaurds? Where exactly is your balance point?
keys85 is offline  
Old December 8, 2008, 04:52 PM   #2
shooterer
Member
 
Join Date: August 22, 2006
Location: WI.
Posts: 64
I balance my rifles at the delta ring

I shoot HP with a "thumb out delta hold" (thumb near ejector port, glove jammed in the gap and fingers facing my shoulder) this hold locks my wrist the best and keeps the muzzle from moving (too much).

My service rifle is at about 15 1/2 lbs. I have a full weight in the hand guard and 7/8 of a wedge in the butt.

Jim
__________________
Stand up for whats right....Even if you stand alone.

Last edited by shooterer; December 9, 2008 at 09:21 AM. Reason: correct weight
shooterer is offline  
Old December 8, 2008, 07:06 PM   #3
kraigwy
Senior Member
 
Join Date: June 16, 2008
Location: Wyoming
Posts: 9,360
Cpt Crossman, in his book recommends that any serivce rifle be held at the mag well (or just ahead of the mag on mag. rifles) When held there the rifle should just start to time at the muzzle end. I believe the all guard teaches this or did when I went to their coaches clinic. I also preached the same thing when I was coaching the AK NG Rifle Team.

My AR Service Rifle (White Oak Upper) is a bit muzzle heavy so I put lead shot into the buttstock until it just starts to tip at the muzzle. Sure helped me.

Of course my AR now weighs 13.5 lbs. But wht the heck, it helps my shooting.
__________________
Kraig Stuart
CPT USAR Ret
USAMU Sniper School Oct '78
Distinguished Rifle Badge 1071
kraigwy is offline  
Old December 8, 2008, 10:05 PM   #4
darkgael
Senior Member
 
Join Date: February 9, 2006
Location: Homes in Brooklyn, NY and in Pennsylvania.
Posts: 4,266
AR

"weighs 13.5 lbs"
That's about what mine weighs. Balance point is ahead of the mag well so that it's a tad heavy toward the muzzle. Just a tad.
Pete
__________________
"Only hunting and mountain climbing are sports. The rest are just games." - R.Ruark
NRA Life Member
darkgael is offline  
Old December 10, 2008, 03:35 PM   #5
4EVERM-14
Senior Member
 
Join Date: November 12, 2006
Location: Pennsy
Posts: 560
I added stick-on wheel weights under the handguards. The rifle balances at the middle of the mag well. Not sure of the total weight. Wife threw the bathroom scale away. Said it was malfunctioning.
__________________
David
NRA Benefactor Member
Distinguished Rifleman #731
Presidents 100
4EVERM-14 is offline  
Old December 10, 2008, 10:16 PM   #6
P-990
Senior Member
 
Join Date: May 2, 2002
Location: Only1/2WayThere
Posts: 1,052
Mine balances right at the delta ring, or close to. I have a WOA Wilson barrel on it right now, and no longer need a forend weight to balance it! And for some reason my buttstock wedge is wedged in place. Luckily there's only about 1/2 of one in there. All up it weighs about 14 pounds on our bow scale at work.

That said, I'm not sure a couple of wheel weights at the forward tip of the float tube wouldn't hurt. Just get it to tip so the muzzle doesn't bounce as hard when I get aggressive on the trigger offhand.
__________________
NRA Master, Highpower Rifle, Across-the-Course
NRA Expert, Highpower Rifle, Mid-Range Prone
P-990 is offline  
Old December 12, 2008, 11:30 PM   #7
wgb_ks
Member
 
Join Date: October 16, 2008
Location: Kansas
Posts: 21
My balance point is slightly behind the delta ring closer to the stock. It seems to work for me. As for the weight of the rifle, currently it is about 17 lbs, and if I could I would make it heavier. I was thinking of putting lead weights in the magazine to help stabilize the rifle more. I heard of AR-15 type service rifles pushing 23 lbs!!!
wgb_ks is offline  
Old December 13, 2008, 08:21 PM   #8
Ken O
Senior Member
 
Join Date: November 2, 2005
Location: Half way between Grayling and Cadillac, Michigan
Posts: 353
When you say AR15 "match" rifle, I assume your talking about a space gun upper. I shoot AR15 "service" rifle competitions with a couple WOP uppers, so not sure if my post pertains. My balance point is about an inch behind the delta ring. I had weight in the handguard, but took it out. I think the float tube adds enough weight.
Ken O is offline  
Old December 14, 2008, 04:38 PM   #9
Tim R
Senior Member
 
Join Date: November 30, 2004
Location: God's side of Washington State
Posts: 1,601
Like Ken 0, I have a couple of WOP service rifle uppers. I have the wedge weight in the butt and weight under the hand guards. I really like the Kreiger in upper #2.
__________________
God Bless our Troops especially our Snipers.
Tim R is offline  
Old December 20, 2008, 02:37 AM   #10
T. O'Heir
Senior Member
 
Join Date: February 13, 2002
Location: Canada
Posts: 3,135
"...I prefer..." That's it. What works for you. However, Ken O has a very good point too. Not all matches are the same.
__________________
Spelling and grammar count!
T. O'Heir is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:29 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07794 seconds with 7 queries